TA Triumph-Adler DC 2020 - Manual (Page 111)

4-29
Section 4 Other Features of this Fax
4. Press an unregistered one-touch key.
* The program key will be registered under that one-touch key.
5. Proceed to the procedure for the desired communication.
A. Standard Transmission ......................................This page
B. Broadcast Transmission...........................................P4-30
C. Polling Reception .....................................................P4-31
2. Use the cursor up or the cursor down key to select “Program
Program key”.
3. Press the Enter key.
ProgramKey:
Press 1-Touch Key
Program:
Program Abbreviated Dial
Program 1-Touch Key
➪ Program Program Key
ProgramKey:05:Select Mode
➪ Send
Broadcast
RX Polling
A. Standard Transmission (Continued from step 5)
6. Make sure that “Send” is selected in the message display.
* If it is NOT selected, use the cursor up or the cursor down key to
select it.
7. Press the Enter key.
8. Use the cursor up or the cursor down key to select whether or not
you want to designate a time for the transmission to begin.
> If you want to designate a time for the transmission to begin,
select “On” and proceed to step 9.
> If you want to have the transmission begin immediately after the
program key is pressed, select “Off” and proceed to step 11.
9. Press the Enter key.
10. Use the keypad to enter the desired time for the transmission to
begin.
* If you want to reset the displayed time to “00:00”, simply press
the Stop/Clear key.
11. Press the Enter key.
12. Enter the destination fax number.
* You can enter the fax number using the keypad, abbreviated
numbers, one-touch keys or the directory. Chain dial keys can
be used as well.
If you enter the fax number using an abbreviated number or
one-touch key that is already designated for F-Code Based
Communication, you can skip steps 13 through 16.
13. If you want to designate this communication as an F-Code Based
Transmission, press the F-Code [SUBADDRESS] key.
> If you pressed the F-Code [SUBADDRESS] key, proceed to
step 14 on pape 4-30.
> If you DID NOT press the F-Code [SUBADDRESS] key,
proceed to step 17 on pape 4-30.
ProgramKey:05:Select Mode
➪
Send
Broadcast
RX Polling
Delayed Comm.:
➪
On
Off
TX Time:17:00
Enter TX Time
v :
Enter Fax No.
Program:
Press one-touch key
Program:05:Select mode
➪
Send
Broadcast
RX polling
Program:05:Select mode
➪
Send
Broadcast
RX polling
TX time:17:00
Enter transmission time
v :
Enter fax number
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
Program:
Program abbreviated dial
Program one-touch key
➪
Program program key
(Inch) (Metric)