Subaru Robin EX30 - Manual (Page 20)

- 17 -
Step Parts to remove Remarks and procedures Fasteners
13 Ignition coil Remove the spark plug cap from the spark plug and
remove the ignition coil from the crankcase. 10 mm box spanner
M6 x 25mm : 2 pcs.
14 Starting pulley Wear work gloves during operation to avoid a possible
injury by a sharp edge.
Remove the starting pulley from the fl ywheel.
Fit a box wrench or a socket wrench on the fl ywheel
nut and loosen the nut by knocking the wrench sharply
with a hammer. (See Figure STEP14-A)
NOTE:
1) Do not insert a screwdriver or other object between
the fl ywheel blades, otherwise the risk of damaging
the blades might be occured.
2) Knock the wrench with a hammer in a counter
clockwise direction.
24 mm box spanner or
socket wrench
M18 nut
15 Flywheel Remove the fl ywheel from the crankshaft. Leave
the nut temporarily to prevent the fl ywheel from
dropping out. Fit the fl ywheel puller as shown in
Figure STEP15-A and remove the fl ywheel from
the crankshaft by rotating the bolt at the center in a
clockwise direction.
(Knock the center bolt with a hammer sometimes) Flywheel puller
STEP 13
STEP 14
STEP 15
STARTING PULLEY
IGNITION COIL
FLYWHEEL
M18 NUT : 1 pc.
M6 x 25 BOLT and
WASHER : 2 pcs.
FLYWHEEL PULLER
ATTACH NUT
TEMPORARILY
STEP14-A STEP15-A