Subaru Robin EX30 - Manual (Page 57)

- 56 -
Since the spiral spring is set in the reel, do not drop or shake it. Put it on a fl at place.
WARNING
-2: Hold up the real gradually and slowly, and remove it from the case.
-3: If the spiral spring in the reel likes to jump out of the reel, stop the procedure and push the reel against the
case to redo the step of section (3)-1 and (3)-2.
Disassembly is completed.
13-2 ASSEMBLY STEPS
(1) Setting the reel into the case.
-1: Peep at the boss of reel to check the inner end of
the spring.
-2: Hook the inner end of spring to the hook of case
and put the reel into the case. (Figure 13-2-A)
(2) Assemble the component parts.
-1: Put the ratchet in the reel so that the receiving
area of the reel is within the area illustrated in
Figure 13-2-B.
-2: Assemble the friction spring to the shaft in the
case.
-3: Insert the legs of friction plate (2 places) in ratchet
holes. (Figure 13-2-C)
(3) Tighten the center screw.
(2 people required for this step.)
-1: Adjust the tip of center shaft to the hole of friction
plate and compress the friction spring by pushing
the friction plate with your fi ngers.
-2: Tighten the center screw counterclockwise (as it is
reverse screw).
Before starting the assembly, make sure to wear the protective glasses.
WARNING
Boss of real
Hook of Case
Inner end
of spring
Wear work gloves during operation to
avoid a possible injury by a sharp edge
of the friction plate.
WARNING
Ratchet hole Leg of Friction plate
Receiving
area of
the Reel
Ratchet Claw
Within
this area
13-2-B
13-2-A
13-2-C