PLANET VIP-193 - Manual (Page 15)

Powering on the Wi-Fi Phone
Make sure you have the account information, including necessary Wi-Fi Phone settings, supplied by your Internet
phone service provider. If you already have an account set up with your Internet phone service provider, then
proceed to step 1. If you do not have an account, then go to the website of your Internet phone service provider
and sign up for service. After you have set up an account, proceed to step 1.
1. Make sure you have the account information, including necessary Wi-Fi Phone settings, supplied by your
Internet phone service provider.
2. Plug the USB mini-B connector of the included power adapter into the USB mini-B port of the Wi-Fi Phone.
Then connect the power adapter to a standard electrical outlet.
3. The power LED will flash, alternating between blue and purple. For the initial charge, allow the battery to
charge for at least 10 hours, so the battery will have a full charge, which is indicated by a solidly lit power
LED. This maximizes battery performance and life.
NOTE: When the battery is low on power, it will emit one warning sound or vibration,
unless the Ring Type is set to Silent. (For more information about Ring Types, refer to
Chapter 4: Configuring the Wi-Fi Phone.”)
When the battery is fully charged, proceed to “Navigating the Wi-Fi Phone.”
Figure 3-3: Connect the Power
8
Chapter 3: Installing and Using the Wi-Fi Phone