ProSoft Technology 5105-103M-PDPS - Manual (Page 52)

Diagnostics and Troubleshooting 5105-103M-PDPS ♦ ProLinx Gateway
User Manual IEC 60870-5-103 Master to PROFIBUS Slave Gateway
Page 52 of 144 ProSoft Technology, Inc.
November 24, 2010
2.1 Using ProSoft Configuration Builder (PCB) for Diagnostics
The Configuration and Debug menu for this gateway is arranged as a tree
structure, with the Main menu at the top of the tree, and one or more submenus
for each menu command. The first menu you see when you connect to the
gateway is the
Main menu.
Because this is a text-based menu system, you enter commands by typing the
[command letter] from your computer keyboard in the Diagnostic window in
ProSoft Configuration Builder (PCB). The gateway does not respond to mouse
movements or clicks. The command executes as soon as you press the
[ COMMAND LETTER ] — you do not need to press [E NTER ]. When you type a
[ COMMAND LETTER ], a new screen will be displayed in your terminal application.
2.1.1 Required Hardware
You can connect directly from your computer’s serial port to the serial port on the
gateway to view configuration information, perform maintenance, and send or
receive configuration files.
ProSoft Technology recommends the following minimum hardware to connect
your computer to the gateway:

80486 based processor (Pentium preferred)

1 megabyte of memory

At least one UART hardware-based serial communications port available.
USB-based virtual UART systems (USB to serial port adapters) often do not
function reliably, especially during binary file transfers, such as when
uploading/downloading configuration files or gateway firmware upgrades.