Enviro EG28 DV - Manual (Page 23)

23
Secondary Installation
I
NSTALLATION OF
L
OG
S
ET AND
E
MBERS
:
The placement of the logs is not arbitrary.
If they are positioned incorrectly, the
flames can be “pinched” and will not burn
correctly. The burner come with five (5)
locator pins and two (2) resing areas,
which make alignment easier. Using the
pictures provided, carefully set the logs in
place.
NOTE: The logs are fragile and should
be handled gently.
CAUTION: Use only the type of ember
material supplied with this appliance. Due
to the irregular size of the ember material
there may be more than required. The use
of other foreign materials on the burners
may create dangerous conditions.
If over time, through cleaning and servicing,
these embers require replacement, contact
the nearest ENVIRO dealer for replacement
embers.
1. The embers can be place before or after
the logs are placed. A bag of ceramic fiber
embers and rock wool embers is provided
gently remove the ember material from
the plastic bag. Spread a layer loosely in a
random manner across the burner tray. Do
not allow any embers to rest against pilot
assembly. (See Figure 33 or 36 for proper
ember placement.)
DO NOT pack this ember material as this
could create an unsafe condition, leave
embers loose
2. Carefully remove logs from box. Check
to ensure there is no damage. It is very
important to install all logs in their proper
position to insure safe, optimum operating
conditions.
3. Place the log set into the firebox.
Locate each log by seating it down onto the
burner tray support pins. Follow Figures 31
to 36 proper log placement.
Figure 31: Step 1 of Log Placement.
Figure 32: Step 2 of Log Placement.
Figure 33: Step 3 of Log Placement.
Figure 34: Step 4 of Log Placement.