Enviro EG28 DV - Manual (Page 24)

Secondary Installation
CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE GLASS DOOR REMOVED.
4. Upon the first light up, watch for
ignition to ALL burner ports. If a
long delay is noted: First, wait for the
appliance to cool down.
• Open the front door of the appliance.
• Check to carefully reposition the
embers making sure that burner ports
are not plugged solid or blocked.
Important note: When the unit is
turned on for the first time, It should be
turned onto high without the fan on for
the first 4 hours. This will cure the paint,
logs, gasket material and the other
products used in the manufacturing
process. It is advisable to open a
window or door, as the unit will start
to smoke and can irritate some people.
After the unit has gone through the first
burn turn the unit off including the pilot,
let the unit get cold then remove the
glass door and clean it with a good gas
fireplace glass cleaner, available at your
local ENVIRO dealer.
See Routine Maintenance And Service
on how to remove door to clean glass.
Figure 36: Log Placement with Embers.
Figure 37: Appliance Burning.
24
Figure 35: Step 5 of Log Placement.