Compactflash card for the adsl nim, Formatting the compactflash card, Figure 2-8 – Enterasys Networks XSR-3150 User Manual
Page 38: Sec urity rout ers, Com pw r sys nim1 nim 2 vp n, Command to restart the xsr in normal mode
Installing a CompactFlash Memory Card
2-6 Hardware Installation
Gently insert the CF into the slot, taking care that the CF’s wider grooved edge fits into the
wider track of the PCMCIA interface. If the card does not seat easily but stops halfway into the
slot, do not force it in - the card was inserted incorrectly. Flip it over and re-insert. Note that
the XSR’s CF eject mechanism pops out for easy removal when you install the card.
Figure 2-8 Installing CompactFlash Card
CompactFlash Card for the ADSL NIM
The ADSL NIM is shipped with a CompactFlash card carrying the DSP firmware necessary for
connecting to a DSAM. Refer to
for an illustration and installation instructions.
Formatting the CompactFlash Card
If your CF is not formatted, there are two ways you can format the card:
•
Use the XSR Bootrom Monitor Mode
ffc
command. A few seconds after you boot up the XSR,
press the
CTRL-C
keys and a password prompt will appear. Press ENTER (factory default) if
you have not defined any password. The Bootrom Monitor Mode will appear. Enter
ffc
and
the router will complete the formatting.
•
Install the CF in a PCMCIA card and enter the Windows format command. For further
instructions, refer to Windows documentation.
•
After completing CF formating via Bootrom Monitor Mode, use the
bc
command to restart the
XSR in normal mode.
NIM 1
NIM 2
1000
GBIC
Link
TX
10/100/1000
10/100/1000
SEC
URITY
ROUT
ERS
XSR-3150
COM
PW
R
SYS
NIM1
NIM
2
VP
N
CO
M
PWR
SYS
NIM1
NIM
2
VPN
COM
ETH
3
ETH
2
ETH
1