Enterasys Networks XSR-3150 - Manual (Page 83)

Bootrom Monitor Mode Commands
XSR Getting Started Guide 3-39
Set working directory to flash:
Using default Bootrom password. The system is not secure!!!
Use “bp” to change password
ffc
This command formats the CompactFlash card.
ng
This command retrieves a file over the network using a remote IP address/file path.
np
This command modifies network parameters. You are prompted to enter data by the following
script. While most of the options are self-explanatory, three require further description.
• When set to no, the Autoboot option places the prompt in Bootrom mode when you boot or
power up the XSR.
• When set to yes, the default Quickboot action of delaying five seconds at startup for you to
optionally enter CTRL-C and acquire Bootrom mode is negated. You can still acquire Bootrom
mode, but you must immediately press CTRL-C upon seeing the X-Pedition Security Router
Bootrom header.
• The default hostname (local target name), XSR-3000, cannot be changed. In the absence of a
user-supplied hostname via the
hostname CLI command, this name will be used as the CLI
prompt and SNMP hostname in MIB-II.
XSR-3150: np
Enter ‘.’ = clear a field; ‘-’ = go to previous field; ^C = quit
Local IP address (192.168.1.1) :
Gateway IP address () :
Remote Host IP address (192.168.1.10) :
Remote file path (c:\)
:
Use TFTP (no) :
Ftp userid (anonymous) :
Ftp password () :
Local target name (robo1) :
Autoboot (yes) :
Quick boot (no) :
Permanently save the network parameters? (y/n)
ns
This command saves a file over the network using a remote IP address/file path.