Enterasys Networks XSR-3150 - Manual (Page 78)

XSR Rebooting Characteristics
3-34 Software Configuration
Testing S/W Integrity << PASSED >>
Loading Router S/W to address 0x80020000
Verifying uncompressed chksum ...
Starting from 0x80020000...
Attaching shared memory objects at 0xa0000600... done
Attaching interface lo0...done
Verifying flash:xsr3000.fls file ...
Router S/W size=11989192 sum=0xedd1 compressed_size=4109639 entry=0x80020000
Diagnostics size=1459880 sum=0x8154 compressed_size=614417 entry=0x80020000
RouterCpu1 S/W size=1520104 sum=0x4a2c compressed_size=652528 entry=0x82020000
Testing S/W Integrity << PASSED >>
Cpu1 software loaded at address 0x82020000, size is 0x001731e8
==cpu1:Running.
******************** REMOTE AUTO INSTALL STARTING *************************
Remote Auto Install Terminating - No Serial Cards Installed
login:
Reboot Triggers
Although there are two types of reboots of the XSR - warm or cold - reboots can be triggered in up
to eight different ways. Refer to the table below.
Power-Up Reboot
If you power cycle the XSR by flipping the switch on the back panel, the XSR will cold reboot. The
startup-config file stored in Flash becomes the running configuration.
Table 1 Reboot Triggers
Cause Boot Type
Power-up Cold
CLI reload Cold or Warm
SNMP reload Cold or Warm
Watchdog Expiration Warm
Software Crash Warm
Repetitive Software Crash Cold
ROM Monitor Cold or Warm
Invalid SW text checksum Warm