Samson AirLine 88x Wireless Guitar System (K: 470 to 494 MHz) - Manual (Page 16)

16
Troubleshooting
Issue Solutions
No Audio
Make sure that the transmitter and receiver are both
powered on.
Ensure the AG8 transmitter’s batteries are fully charged.
Check that the transmitter is not muted.
Confirm that the CR88x adapter is correctly connected
and plugged into an electrical outlet.
Turn on the CR88x receiver.
Make sure the CR88x audio output connections are
securely connected.
Ensure that the receiver and transmitter are in line of
sight with one another.
Check the receiver and audio input device level controls.
Ensure that the transmitter and receiver are set to the
same operating channel. If unsure, reset the channel by
following the steps in the “Quick Start”.
Distorted Audio
The receiver output level or audio input device level may
be too high.
The input gain on the transmitter (AG8) may be too high.
Audio Dropout
The transmitter may be too far away from the receiver.
Move it closer to the receiver, or reposition the antennas.
Remove any sources that may cause RF interference
such as cell phones, cordless phones, lighting
equipment, computers, metal structures, etc.
Receiver will not power
on Check the adapter to ensure it is properly connected and
plugged into an outlet providing power.
Transmitter will not
power on
Ensure the AG8 transmitter’s batteries are fully charged.
Unwanted noise or
interference
If using multiple systems, make sure none of the
systems are operating on the same channel. If the
problem persists, change one or all of the systems
channels.