Samson AirLine 88x Wireless Guitar System (K: 470 to 494 MHz) - Manual (Page 9)

AirLine 88x Wireless System 9
Quick Start - Single System Setup
When the transmission is complete, the CR88x will
receive RF signal and the tone key from the trans-
mitter. The READY indicator will light on the front
panel of the CR88x receiver.
Turn on your connected amplifier or mixer, but keep
the volume all the way down. Set the Volume knob
on the CR88x fully clockwise (to its “10” setting).
This is unity gain.
Play your instrument at normal performance level.
Slowly raise the volume of your amplifier or mixer until the desired level is reached.
If you find the system has noticeable dropouts, reduced overall working range, or unexpected
noise bursts, change the operating channel of the system using the steps above.
3. Plug in receiver 4. Turn on receiver 5. Plug receiver into audio system 6. Press Select button to change channel 9. Press and hold SELECT button to IR set 10. Adjust Volume control 7. Install batteries 8. Press button on transmitter to turn on
9. Press and hold Select button to IR set 7. Install batteries 8. Turn on belt pack transmitter
Multiple System Setup
When using multiple systems, each system must be set to a different operating channel. Transmitter
and receiver pairs must be on the same channel plan in order to work together.
When setting an additional transmitter, make sure to move all other transmitters away from the
CR88x receiver to prevent setting multiple transmitters to the same channel.