Samson AirLine 88x Wireless Guitar System (K: 470 to 494 MHz) - Manual (Page 8)

8
Quick Start
Note: The AG8 will only accept infrared transmission from the receiver for the first 10
seconds after the AG8 is powered on. If you need to change the operating channel,
the AG8 must be first powered off, then powered on again to receive the new channel.
Press the SCAN button for more than 2
seconds (the display will start to flash quickly)
on the front of the CR88x receiver to scan
for an available channel. Once the optimal
channel is selected the receiver will enter IR
Set mode. The display will flash slowly in IR
Set mode.
If you want to set a transmitter to the
receiver’s currently selected channel, press
and hold the SCAN button for more than 10
seconds (until the display flashes slowly) to
enter IR Set mode directly.
3. Plug in receiver 4. Turn on receiver 5. Plug receiver into audio system 6. Press Select button to change channel 9. Press and hold SELECT button to IR set 10. Adjust Volume control 7. Install batteries 8. Press button on transmitter to turn on
9. Press and hold Select button to IR set 7. Install batteries 8. Turn on belt pack transmitter
Position the AG8 transmitter about 3–12” (8–30 cm) from the front of the CR88x with the
transmitter’s IR window facing the IR transmitter on the front panel of the CR88x receiver.
When the transmission is complete, the CR88x
will receive RF signal and the tone key from the
transmitter. The READY indicator will light on the
front panel of the CR88x receiver.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
FREQ:
542-566MHz
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
FREQ:
542-566MHz
3. Plug in receiver 4. Turn on receiver 5. Plug receiver into audio system 6. Press Select button to change channel 9. Press and hold SELECT button to IR set 10. Adjust Volume control 7. Install batteries 8. Press button on transmitter to turn on
9. Press and hold Select button to IR set 7. Install batteries 8. Turn on belt pack transmitter