Samson AirLine 88x Wireless Guitar System (K: 470 to 494 MHz) - Manual (Page 7)

AirLine 88x Wireless System 7
In order for your wireless system to work correctly, both the receiver and transmitter must be set to the
same channel.
Follow this basic procedure for setting up and using your AirLine 88x Guitar wireless system:
Physically place the CR88x receiver where it will be used, and extend the antennas vertically.
The general rule of thumb is to maintain “line of sight” between the receiver and transmitter so
that the person using the transmitter can see the receiver.
With the CR88x receiver powered off, connect the included power adapter. Turn the CR88x
on momentarily to confirm that the unit is receiving power. You’ll see the LED display light up.
Then turn the CR88x power off.
With your amplifier or mixer off and volume control all the way down, connect the CR88x
receiver to the input of an amplifier or the mic or line level input of a mixer using the balanced
XLR output or unbalanced 1/4”output. Turn the Level knob on the CR88x completely
counterclockwise, then turn its power on.
Quick Start
With the AG8 powered off, install a
fresh AA battery. Be sure to observe the
plus and minus polarity markings.
Turn on the power to the
transmitter by sliding the
Power switch to the left.