Connecting to an hdbaset transmitter – Epson PowerLite 2250U 5000-Lumen WUXGA 3LCD Projector User Manual
Page 45
45
• Connect the red and white plugs on the other end of the cable to the projector's
L-Audio-R
ports.
Parent topic:
Connecting to an HDBaseT Transmitter
To send an HDMI or RS-232C signal over a long distance, you can connect the projector to an optional
HDBaseT transmitter using a 100Base-TX network cable (PowerLite 2165W/2265U). This is useful when
you want to send a signal to or control the projector from a remote location, such as in a hall or event
site, since you can use a network cable up to 328 feet (100 m) in length. To ensure proper data
transmission, use a Category 5e STP cable or better.
1.
Turn off the projector and HDBaseT transmitter.
Note:
Make sure the projector and HDBaseT transmitter are turned off when connecting or
disconnecting a network cable between the two devices.
2.
Connect one end of the network cable to the
HDBaseT
port on the transmitter.