Connection, Connecting the vga input, Connecting the touch module – BenQ RM8602K 86" Class 4K UHD Educational Touchscreen LED Display User Manual
Page 19
Connection
19
Connection
Connecting the VGA input
1. Connect the
VGA
jack on the display to the VGA output jack on a computer using a
D-Sub (15-pin) cable.
2. Connect the computer’s audio output jack to the
AUDIO IN
/
MIC IN
jack on the
display with a suitable audio cable.
Connecting the touch module
Connect the
TOUCH
(type B) jack on the display to the USB port of a computer using
the supplied USB cable. The touch module of the display supports easy Plug-and-Play
operation. There is no need to install additional drivers on the computer.
• Avoid blocking the touch screen frame (where sensors are located) when initiating the touch
module.
• It is highly recommended that you connect the display to the PC or laptop directly. Avoid
connecting the display to a face plate device which may cause failures in touch operations.
• If any ghost image occurs, please try to un-plug and then re-plug all USB cables. If the failure
image still exists, use another USB type B to A cable.
•
TOUCH 2
port must be connected with
HDMI IN
3
or
VGA
.
D-Sub (15-pin)
cable
Audio
cable
HDMI
cable
USB cable
Computer