Torso Electronics T-1 16-Track Algorithmic Desktop Sequencer - Manual (Page 170)

170 The T-1 Notebook : Reference & Guide
NOTES
▌ CHANGING T-1 CC KNOB ASSIGNMENTS
1. Press [BANK] to ensure the ‘home’ track view is in focus.
2. Select a track in CC mode. Hold [CTRL] + [VBx] where ‘x’ is the value
button for the track to select. CC Tracks will illuminate CYAN ⬛ . Notes
tracks will illuminate ORANGE ⬛ and FX Tracks are coloured
MAGENTA ⬛ .
3. The 14 rotary knobs in the Shape, Groove and Tonal section will be
preassigned to CC numbers, 70-76 Top row and 77-83 bottom row or
will contain edited CC number assignments.
4. The mapping of the external device parameters is usually documented
in the manual. This is called the ‘MIDI Implementation’ of a device. CC’s
would normally be defined based on the target parameters required.
5. Enter edit mode for CC assignments:
• Double Press (Knob), for the rotary knob to edit. The value will be
shown on the value buttons.
• Press [CTRL] + [PATTERN] to enter CC edit mode.
• The display is now locked to the CC edit view.
6. To check or edit the setting, example sets the value of velocity from the
default 74 to 95:-
• Press [VB14]. This represents the ‘100’ digit range. Press to toggle
[VB1] = ‘0’ or [VB2] = ‘1’. These toggle the hundreds digit. In this
example, should be off for 095.
• Press [VB15]. This represents the ‘100’ digit range. Press to toggle
[VB1] = ‘0’ to [VB10] = ‘9’. These toggle the tenths digit. In this
example, should be [VB10] for 095.
• Press [VB16]. This represents the ‘100’ digit range. Press to toggle
[VB1] = ‘0’ to [VB10] = ‘9’. These toggle the units digit. In this
example, should be [VB6] for 095.
7. Once completed, press [CTRL] + [BANK] to switch to the selected
parameter value view or press [BANK] to return to the track home view.
MIDI & WiFi Connectivity
8