Eaton Electrical Powerware 9130 - Manual (Page 62)

COMMUNICATION
Eaton ® 9130 UPS (700–3000 VA) User's Guide
S
164201718 Rev 2 www.powerware.com 54
Installing Communication Options and Control Terminals
To install the communication options and control terminals:
1. Install the appropriate connectivity card and/or necessary cable(s)
and connect the cables to the appropriate location.
See Figure 18 and the following section, “Communication
Options,” for detailed information.
2. Route and tie the cable(s) out of the way.
3. Continue to “Operation” on page 37 to start up the UPS.
Communication Options
The Eaton 9130 has serial communication capabilities through the USB
and RS-232 communication ports or through a connectivity card in the
available communication bay.
The UPS supports two serial communication devices according to the
following table:
Independent Multiplexed
Communication Bay USB RS-232
Any connectivity card Available Not in use
Any connectivity card Not in use Available
NOTE You can configure relays, signal inputs, and the serial port baud rate through the
front panel menus (see Table 3 on page 40).
NOTE The communication speed of the USB port is fixed at 9600 bps.
RS-232 and USB Communication Ports
To establish communication between the UPS and a computer, connect
your computer to one of the UPS communication ports using an
appropriate communication cable (not supplied). See Figure 18 for the
communication port locations.