Moog Subharmonicon Semi-Modular Polyrhythmic Analog Synthesizer - Manual (Page 34)

35
ROW FIVE (Continued)
RESET INPUT
A trigger signal received here will reset the sequencers to Step 1, and will reset
the rhythm generators to their initial phase or starting point. If the
PLAY button
was lit when the trigger was received, the sequencers will begin again on the
next clock pulse. If the
PLAY button was unlit when the trigger was received,
the sequencers will not restart until the PLAY button is pressed again. A gate
signal received here will act as a Hold function. The sequencers will reset to
Step 1, but will not advance to the next step until the gate signal has ended.
However, the EGs will continue to be triggered by the rhythm generators
assigned to that sequencer. Pressing the NEXT button while the gate signal is being received will
advance the sequencers to the next step, where the EGs will continue to be triggered by the rhythm
generators assigned to that sequencer. Normal playback will resume when the gate signal has ended.
CV INPUT: 0V to +10V
(Rising edge = TRIGGER; Continuous high voltage = GATE)
TRIGGER INPUT
A control signal received here will trigger the VCF EG and the VCA EG
(Envelopes) to begin their cycles. Note that the EGs will
NOT restart if
they are currently in the Attack stage.
CV INPUT: 0V to +10V
(Rising edge = TRIGGER)
VCF EG OUTPUT
The control signal created by the VCF EG (Envelope) is available via this jack.
CV OUTPUT: 0V to +8V
ROW SIX
RHYTHM 1 INPUT
A control signal connected to this input sets the timing of Rhythm Generator 1
by controlling the value of the
RHYTHM 1 knob, thereby selecting the integer
value (1-16) used to divide the current tempo. RHYTHM 1 knob should be
centered for the best range.
CV INPUT: -5V to +5V
RHYTHM 2 INPUT
A control signal connected to this input sets the timing of Rhythm Generator 2
by controlling the value of the
RHYTHM 2 knob, thereby selecting the integer
value (1-16) used to divide the current tempo. RHYTHM 2 knob should be
centered for the best range.
CV INPUT: -5V to +5V
THE PATCHBAY
(Continued)