Edelbrock 1465 - Manual

®
Off-Road Needle & Seat Assembly
for Performer Series Carburetors
Catalog # 1465
Installation Instructions
)
Please study these instructions carefully before installing your Off-Road needle & seat assembly. If you have any
questions or problems, do not hesitate to contact our Technical Hotline at: (800) 416-8628 from 7:00 am to 5:00
pm, Monday through Friday, Pacific Standard Time or e-mail us at: [email protected].
)
Use Owner's Manual supplied with carburetor for disassembly and reassembly.
)
Remove original needle and seat assembly and replace with #1465 (Figure 1). To reset float level, see Figure 2 for proper
offroad setting (7/16").
OFF-ROAD FLOAT LEVEL
With bowl cover inverted, bowl cover gasket in place, and
weight of float seating needle, there should be 7/16" between
top of each float and bowl cover gasket (at outer end). The
sides of floats should be parallel to the outer edge of the bowl
cover. To adjust, bend float lever.
CAUTION! DO NOT PRESS NEEDLE INTO SEAT WHEN
ADJUSTING FLOAT LEVEL.
Brochure #63-0162
© 2002 Edelbrock Corporation Rev. 12/02
Needle and Seat assembly
BEND HERE
MEASURE AT
OUTSIDE END
7/16"
Figure 1
Figure 2