Epson Equity 320SX PLUS - Manual (Page 167)

If
youselect Log errors on disk,
the program displays this
submenu:
Floppy disk A:
Floppy disk B:
Hard disk C:
Hard disk D:
(You do not see drive D unless you have a second hard disk
drive.) Press 1 or ? to highlight the disk on which you want
to log
the error messages and press Enter. The program
creates a file called ERROR.LOG in the current directory of
the specified disk drive. After running the tests, you can open
the ERROR.LOG file to review the errors that occurred during
the tests.
The program uses this device for error logging until you
change it or indicate you do not want error logging. When
you specify a new device, the program erases the existing
ERROR.LOG file, if any.
When you
specify
the device for error logging, one of these
error messages may appear:
Floppy disk A not present
Floppy disk B not present
Hard disk C not present
Printer port not present
Serial port not present
Error in printer status
Error in serial port status
Error in floppy drive A
Record the error message and select a different device for
error logging.
Once you set the run time parameters, you are ready to select
the test(s).
Performing System Diagnostics B-7