Epson Equity 320SX PLUS - Manual (Page 191)

Accessing Your Current Password
If you have forgotten your current password and cannot use
your computer, follow these steps:
1. Turn off the computer and follow the instructions under
“Changing the Jumper Settings” in Chapter 6 to disable
the password function by setting jumper J2 to position A.
Caution
Be sure to ground yourself on the back inside panel of
the computer before touching any of the interior
components. Always replace the cover on the
computer before you turn it on again.
2. Turn on the computer.
You
do not see the
Enter
Password
prompt.
3.
When the
Press <Del>to start SETUP
prompt
appears, press Del.
4. Highlight
Run SETUP
and press Enter. You see the SETUP
menu.
Follow the instructions in Chapter 2 to either set a new
password or select
Not
Instal1ed (if you do not want to
set a new password). Be sure to save your SETUP
information when you exit the program.
5. Turn off the computer and follow the instructions under
“Changing the Jumper Settings” in Chapter 6 to enable
the password function by setting jumper J2 to position B.
6. If you do not have a hard disk, insert the Startup diskette
in drive A. Turn on the computer.
If you set a new password, you see the
Enter Password
prompt. Enter the password to access your system. (See
“Using the Password” in Chapter 3.)
C-6
Troubleshooting