Focusrite RedNet AM2 Stereo Dante Headphone Amplifier and Line-Out Interface - Manual (Page 11)

11
ID (Identification)
Clicking on the ID icon will identify the physical device being controlled by cycling its front panel
“Network” and “Signal” LEDs through green–orange–red states for 10 seconds.
tools Menu
Clicking on the Tools icon will gain access to the following system settings:
Line Level setup – Sets the analogue line output level at 0 dBFS:
• +18 dBu
• +24 dBu
(factory default setting)
Mute (Line out) – On/Off state.
Mute on Power-up – On/Off state (factory default is On).
Attenuation (Headphone) – The headphone output volume can be attenuated for safety. Available
settings are:
• 0 dB
• 6 dB
• 12 dB
(factory default setting)
Preferred Master – On/Off state.