Focusrite RedNet AM2 Stereo Dante Headphone Amplifier and Line-Out Interface - Manual (Page 13)

13
PeRfoRMAnCe AnD sPeCIfICAtIons
Line Level outputs
All measurements taken at +24dBu reference level, maximum gain, R
L
= 100k Ω
0 dBFS Reference Level +18 or +24 dBu (switchable)
Frequency Response 20Hz – 20kHz ±0.5dB
THD + N < -100dB (0.001%) unweighted, 20Hz - 20kHz; -1dBFS input
Dynamic Range 120dB ‘A’-weighted (typical), 20Hz - 20kHz
Crosstalk
(Output to Output)
< -100dB unweighted, 20Hz - 20kHz; -20dBFS input
Headphone output
All measurements taken at +19dBm reference level, maximum gain, R
L
= 600 Ω
0 dBFS Reference Level +19dBm
Frequency Response 20Hz – 20kHz ±0.5dB
THD + N < -100dB (0.001%) unweighted, 20Hz - 20kHz; -1dBFS input
Dynamic Range 118dB ‘A’-weighted (typical), 20Hz - 20kHz
Output Impedance 5Ω
Headphone Impedance 32Ω – 600Ω
Crosstalk
(Output to Output)
< -90dB unweighted, 20Hz - 20kHz; -20dBFS input
Digital Performance
Supported sample rates 44.1 / 48 / 88.2 / 96 kHz (-4% / -0.1% / +0.1% / +4.167%) at 24 bit
Clock Sources Internal or from Dante Network Master
Connectivity
front Panel
Headphone 1/4” stereo Jack socket
Rear Panel
Line Output 2 x XLR-3 male
PSU (PoE and DC) 1 x PoE (Network Port 1) Input and 1 x DC 12V Barrel Input Connector.
Network
2 x etherCON NE8FBH, also compatible with standard RJ45 connectors
(Accomodates rugged etherCON NE8MC*. Does not intermate with Cat 6 cable connector
NE8MC6-MO and NKE65* cable)