Edelbrock Yamaha 9355 - Manual (Page 2)

Twist Throttle Installation
1. Install pull cable (see Figure 5) end into
the 4:00 position of the cable wheel and
the return cable into the 1:00 position.
Secure cables into cable bracket by
replacing end piece and phillips screw.
See figure 6.
Figure 5.
Figure 6.
3. Place supplied hose clamp over
rubber hose and carburetor.
4. Align carburetor as close to vertical
as possible and tighten both
clamps on each end of carburetor.
5. Adjust pull cable until wide-open
throttle is achieved. Adjust return
cable to take up the slack (for twist
throttle only). Note: When throttle
cables are adjusted properly,
there should be approx. 1/8” of
free play in the throttle.
6. After throttle cables have been
adjusted the handle bars should be
rotated from full right stop to full left
stop while opening and closing
throttle to ensure smooth
operation. Also check to make
sure the cables do not catch or
bind on anything, i.e., hand
guards, stabilizers.
7. Connect crank vent line to the
plastic elbow on upper left side of
the plenum.
8. Install remote idle cable into
threaded tab on top of carburetor.
Refer to main instruction for remote
idle cable installation and
adjustment.
9. Install fuel tank and connect fuel
line to petcock and secure with
remaining pinch clamp. Turn fuel
on and check for leaks.
10. Open throttle 3-5 times to prime
accelerator pump. Do not open
throttle any more than 5 times as
this may flood engine!!
11. Install air box bolts back into frame
to secure air box.
NOTE: If flooding occurs, slowly
open throttle about half way and
hold. With throttle still open,
engage starter until engine fires
For any questions regarding
tuning or installation of Edelbrock
products, please call our toll free
tech line M-F 8:00am-12: 30pm,
1:30pm-5:00pm PST.
877-888-7504 ext.2.
Edelbrock #3026 and 3154
Carburetor Specifications
Bore Size: 36mm tall X 42mm wide
Needle: 19E @ 12 clicks
Accelerator Pump Bypass: 1 3/4
turns out.
Alternate Needles: 17E, 21E
Replacement Throttle Cables:
THUMB-#9339
TWIST-#9355
Pull Cable