Tilta Nucleus-Nano II FIZ Wireless Lens Control System - Manual (Page 24)

FIRMWARE UPDATE
22
！
SERVER
China
Worldwide
To check if the hardware needs an update:
Check if there is a version number with an arrow "→"
below the hardware. If there is, it means the current version
requires a firmware update, as shown below.
MOTOR-M
XXXXXX→XXXXXX
MOTOR-M
XXXXXX
If there is no version number with an arrow "→" below
the hardware, it means the current version does not require
a firmware update, as shown below.
NUCLEUS NANO II MOTOR
NUCLEUS NANO II HAND WHEEL CONTROLLER
02 Enter the hand wheel controller’s menu, select SYSTEM - FIRMWARE UPDATE , choose to update the motor, such as MOTOR-M
and click CONFIRM to start the update. Once the update progress reaches 100%, the update is complete. If you need to update
When the hand wheel controller is already connected to the
internet, access SYSTEM - FIRMWARE UPDATE .
ASERVERwindow will pop up. Please select the
appropriate server based on your location, and then
proceed with the update.
Before updating the motor firmware, make sure that the hand wheel controller has previously updated to the latest version.
Before updating, ensure that the hand wheel controller has a battery level of at least 50% and no other motors are currently
undergoing a firmware update.
During the update process, do not plug or unplug the motor's power or turn off the hand wheel controller. If this happens, reconnect
the motor's power and repeat the update operation.
Multiple motors cannot undergo firmware updates simultaneously. Only one motor can be updated at a time to avoid signal
interference.
When completing firmware updates, if proceeding with the next firmware update, you need to disconnect the motor's power
before proceeding.
The motor needs to be paired with the hand wheel controller before viewing the current version number of the firmware update.
If the motor accidentally enters firmware update mode by pressing the FUNCTION button, please disconnect the motor’s
power first and reconnect power.
If the update progress remains between 5% and 6%, or if the download speed is too slow, please turn off the hand wheel controller
and restart it. Then repeat the above-mentioned update steps.
When the hand wheel controller is connected to the internet, the system will automatically detect the latest firmware version.
During the update process, the screen will restart. Please wait for the update to complete. After finishing, the controller’s menu
will return to the main interface.
When updating the HAND WHEEL-M hardware, firmware for other hardware such as HAND WHEEL-S , MOTOR-M ,
MOTOR-S ,and CONTROL HANDLE will be downloaded simultaneously. Subsequent updates for motors and handles
will not require an internet connection.
After updating the handwheel, check the current firmware version.
If the controller fails to update in a connected state or if the update is interrupted, please check the network status or restart the
controller.
HAND WHEEL-M : Hand Wheel main control firmware
HAND WHEEL-S : Hand Wheel peripheral device management firmware
MOTOR-M : Motor-end camera control firmware; MOTOR-S : Motor control firmware
CONTROL HANDLE : Control handle firmware
SYSTEM
INFORMATION
LANGUAGE
FIRMWARE UPDATE
SYSTEM FIRMWARE
UPDATE
MOTOR-M
MOTOR-S
CONTROL HANDLE
XXXXXX→XXXXXX
XXXXXX
FIRMWARE
UPDATE
MOTOR-M ���%
MOTOR-S
CONTROL HANDLE
XXXXXX→XXXXXX
XXXXXX CONFIRM CANCEL
CONFIRM UPDATE
MOTOR-M
MOTOR-S afterward, you should first disconnect the motor's power and then repeat the above update process.