Copying with one 3 1/2 -inch diskette drive, Copying with one 3 -inch diskette drive – Epson Y16499100301 User Manual

Page 73

Advertising
background image

and press

Enter.

MS-DOS prompts you to insert your

diskettes:

Insert SOURCE diskette in drive A:

Insert TARGET diskette in drive B:

Press any key when ready . .

4. Insert the diskette you want to copy from in drive A and

the diskette you want to copy to in drive B. Then press

any key.

DISKCOPY checks to see if the target diskette is formatted.
If it is not, DISKCOPY formats the diskette. You see the
message:

Formatting while copying

The copy operation begins when the format is complete.

You see this message:

Copying 80 tracks
9 Sectors/Track, 2 Side(s)

5. When the copy is complete, you see this message:

Copy another diskette (Y/N)?

Your diskette has now been copied and you can either

make another copy or leave the DISKCOPY command.

Press Y to perform another copy or

N

to end the

DISKCOPY command.

Copying with one 3 -inch diskette drive

1. First be sure your original diskette is write-protected.

(See Chapter 3 for instructions.)

2. Insert the working copy of your MS-DOS system diskette

in drive A or type C: to log on to drive C, the hard disk.

3. At the A> or C> prompt, type:

DISKCOPY

and press

Enter.

Using MS-DOS With

the Equity LT

4-9

Advertising