IOGear Ethernet-2-WiFi Universal Wireless Adapter - Manual (Page 19)

19
14. Close your browser and change the network settings on your computer back to
DHCP. Refer to steps 4 through 6.
15. Your Ethernet-2-WiFi adapter configuration is complete. Use the included
Ethernet cable to connect the adapter to your Ethernet enabled device such as
a Blu-Ray player, HDTV or game console.
Note : Make sure to set your Ethernet device’s network connection setting to WIRED
for proper operation.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference,
and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Compliance Information