Network menu (eb-g5300/g5200w/g5100 only) – Epson EB-G5200W User Manual
Page 48
List of Functions
48
Network Menu (EB-G5300/G5200W/G5100 only)
When "Network Protect" is set to "On" in "Password Protect", a message is displayed and the settings cannot be changed. You can make changes after
setting "Network Protect" to "Off". s
Sub Menu
Function
Wired LAN
You can make network settings.
DHCP: You can set whether or not (On/Off) to use DHCP.
If this is set to "On" you cannot set any more addresses.
IP Address: You can input the IP address assigned to the projector.
*1
You can enter a number from 0 to 255 in each field of the address. However, the following IP addresses cannot be used.
0.0.0.0, 0.x.x.x, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Subnet Mask: You can input the subnet mask for the projector.
*1
You can enter a number from 0 to 255 in each field of the address. However, the following subnet masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address: You can input the IP address for the gateway for the projector.
*1
You can enter a number from 0 to 255 in each field of the address. However, the following gateway addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
MAC Address: You can display the MAC address for the projector.
PJLink Password
Enter a password to use when you access the projector using compatible PJLink software.
*1
You can enter up to 32 single-byte alphanumeric characters.
Web Control
Password
Enter a password to use when making settings and controlling the projector using Web control.
*1
You can enter up to 8 single-byte alphanumeric
characters.
Web control is a computer function that allows you to set up and control the projector by using the Web browser on a computer running EMP
Monitor. s
EMP Monitor Operation Guide