Epson EB-G5200W - Manual (Page 53)

List of Functions 53
f Wireless LAN menu (only when the optional wireless LAN unit is installed)
Sub Menu Function
Connection mode When the projector is connected to a computer with EMP NS Connection, set so that it is in a permanently connected mode.
Setup by WPS When using a WPS (Wi-Fi Protected Setup) compatible access point via a wireless LAN, you can easily connect the projector to the access point
and make security settings. s
p.95
Antenna level Displays the wireless LAN wave strength.
Wireless LAN
system Sets the wireless LAN system.
SSIDg Enter an SSID. When an SSID is provided for the wireless LAN system in which the projector participates, enter the SSID.
You can enter up to 32 single-byte alphanumeric characters.
DHCPg You can set whether or not (On/Off) to use DHCP.
If this is set to "On" you cannot set any more addresses.
IP Addressg You can input the IP address assigned to the projector.
You can input a number from 0 to 255 in each field of the address. However, the following IP addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Subnet Maskg You can input the subnet mask for the projector. You can input a number from 0 to 255 in each field of the address. However, the following subnet
masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Addressg You can input the IP address for the gateway for the projector.
You can input a number from 0 to 255 in each field of the address. However, the following gateway addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
MAC Address Displays the MAC address.