Epson EB-G5200W - Manual (Page 86)

Replacing Consumables 86
A
After you turn off the projector's power and the
confirmation buzzer beeps twice, disconnect the
power cable.
B
Wait until the lamp has cooled down, then remove
the projector's lamp cover.
Loosen the lamp cover fixing screws with the screwdriver supplied
with the new lamp or a + head screwdriver, and then remove the
lamp cover. Because there is a string attached to the lamp cover to
prevent it from falling, it should never fall even when replacing the
lamp in a projector installed on the ceiling.
C
Loosen the two lamp fixing screws.
D
Take out the old lamp.
If the lamp is cracked, replace it with a new lamp, or contact your
local dealer for further advice.
s Epson Projector Contact List
Caution
Wait until the lamp has cooled down sufficiently before removing
the lamp cover. If the lamp is still hot, burns or other injuries may
result. It takes about one hour after the power has been turned off
for the lamp to be cool enough.
Procedure