JennAir Euro-Style Series 30 Inch Double Combination Smart Electric Wall Oven Flush Installation Instructions - Manual (Page 10)

10
5. Replace the oven racks.
6. Replace the oven door. See the “Replace Oven Door(s)”
section.
7. Check that the door is free to open and close. If it is not,
repeat the removal and installation procedures. See the
“Prepare Built-In Oven” section.
8. Repeat for lower oven door.
9. Reconnect power.
10. The display panel will light briefly and “PF” should appear
in the display.
11. If the display panel does not light, refer to the “Assistance
on Service” section of the Use and Care Guide provided
with your built-in oven or contact the dealer from whom
you purchased your oven.
Complete Installation
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For oven use and cleaning, read the Use and Care Guide.
Check Operation of Single and Double Ovens
1. Turn on power.
2. At first use, set up the clock and any other preferences
if available. For more information, read the Use and
Care Guide.
3. Press BROIL on single oven models.
NOTE: Press UPPER BROIL or LOWER BROIL on double
oven models.
4. Set the temperature.
5. Press START.
If oven(s) does not operate, check the following:
■ Household fuse is intact and tight or circuit breaker .
has not tripped.
■ Electrical supply is connected.
■
See “Troubleshooting” section in the Use and
Care Guide.
6. When oven has been on for 5 minutes, feel for heat.
If you do not feel heat or if an error message appears in the
display, turn off the oven and contact a qualified technician.
7. Press UPPER CANCEL/LOWER CANCEL on double ovens,
or press CANCEL on single ovens.
If you need Assistance or Service:
Please reference the “Assistance or Service” section of the Use
and Care Guide or contact the dealer from whom you purchased
your built-in oven.