Epson 4003353 User Manual
Page 70
Stylus Color service Manual
Disassembly and Assembly
3.2.4 Printer Mechanism
Removal
1. Remove the uppercase. (See
2. Remove the power supply unit. (See section 3.2.2.)
3. Remove the main controller. (See section 3.2.3.)
4. Remove
4
screws and take out the printer mechanism.
■
Wipe off any ink around the end of
ink drain
when you remove the printer
mechanism.
When reinstalling the printer mechanism, check that the waste ink drain tube is properly
inserted between the
lower case
and
the waste ink
CBN(M4X13)
“
.
Figure 3-7. Printer Mechanism
■
When
or
mechanism
the block
must be replaced
at location
and
on the
board. (Every spare
or spare printer
mechanism comes
a block resistor that specially selected for each
■
Adjust both the head gap and the
when
the
mechanism.
Rev. A
3-7