Eiki LC-SD15 - Manual (Page 42)

42
Setting
Remote control
Remote control
Two different remote control codes are assigned to this projector;
the factory-set normal code (Code 1) and the secondary code
(Code 2). This switching function prevents interference with
different remote controls when several projectors or video
equipment nearby are used at one time.
When operating the projector in “Code 2”, the code for both the
projector and remote control must be switched to “Code 2”.
To change the code of the projector :
Set the remote control in the Setting Menu to “Code 2.”
To change the code of the remote control :
Press and hold both MENU and IMAGE buttons on the remote
control for more than 10 seconds. After changing the code, make
sure the remote control operates properly.
To return to the normal code (Code 1), follow the above steps to
operate both the projector and remote control.
Press and hold the
MENU and IMAGE
buttons for more than
10 seconds.
✔
Note:
• When the batteries of the remote control are replaced, the remote control code
automatically returns to the normal code (Code 1).
Key lock
This function locks operation of the top control and the remote
control. It helps to prevent operation by an unauthorized person.
. . . not locked.
. . . lock operation of the top control. To unlock, use the
remote control.
. . . lock operation of the remote control. To unlock, use
the top control.
If the top control accidentally becomes locked and you do not have
the remote control nearby, unplug the AC power cord from an AC
outlet. While pressing the SELECT button, reinsert the AC power
cord. This will cancel the top control lock.
Key lock
Select Key lock
and this box
appears. Choose
one of them with
the Point ed
buttons and select
[Yes] to activate it.