Eiki LC-SD15 - Manual (Page 9)

9
Part Names and Functions
RESET button
A built-in micro processor that controls this unit may occasionally malfunction and
needs to be reset. This can be done by pressing the RESET button with a pen,
which will shut down and restart the unit. Do not use the RESET function
excessively.
Rear Terminal
MONITOR OUT
AUDIO IN VIDEO SERVICE PORT
RESET
COMPUTER / S-VIDEO
/COMPONENT IN
AUDIO OUT
(VARIABLE)
q w e r
t y
w AUDIO IN (Stereo)
Connect audio output from computer or video
equipment connected to q or y to this jack. (p15, 16)
t MONITOR OUT
This terminal outputs the signal coming from
COMPUTER / S-VIDEO / COMPONENT IN terminals.
(This terminal cannot output RGB(Scart) signal from
COMPUTER / S-VIDEO / COMPONENT IN terminals.)
(p15)
y COMPUTER / S-VIDEO / COMPONENT IN
Connect S-video output, RGB Scart 21-pin video output,
component video output or computer output to this
connector. (p15, 16)
e AUDIO OUT(VARIABLE)
Connect external audio amplifier to this jack. (p15, 16)
This terminal outputs the sound coming from AUDIO IN
terminal.
Pa
rt
Names and Functions
q VIDEO
Connect composite video output from video equipment
to VIDEO jack. (p16)
✽
r SERVICE PORT
This jack is used to service the projector.
✔
Note:
• AUDIO OUT and MONITOR OUT terminals work only when the projector is under operation and do not work when the projector is in stand-by state or Power
management mode (p41).
✽