HP FIBRE CHANNEL TO SCSI ROUTER M8201R - Manual (Page 51)

M8201R Fibre Channel to SCSI Router Installation and User’s Guide — 529971-005
C- 1
C
Configuring OSM for Monitoring the
Fibre Channel to SCSI Router
This section includes the steps that are needed to configure OSM so that it can monitor
the Fibre Channel to SCSI router.
To configure OSM for monitoring the router complete these three basic steps:
1. Connect the router to the LAN connection on the system.
2. Configure the router's IP address, user name, and password.
3. Configure the router for OSM monitoring.
You need these components:
•
A M8201R Fibre Channel to SCSI router
•
A system console with a hyper terminal installed
•
A serial cable
•
A system console with a serial cable port
Connecting the Hardware
To connect the router to the LAN connection on the system, make these connections to
the Fibre Channel to SCSI router:
1. Connect the router to the FCSA on the system by using a fiber-optic cable.
2. Connect the tape drive to the router by using a SCSI cable.
3. Connect a serial cable to the system, and then connect the other end of the cable
to the serial port on the router.
Note. For more information on connecting the router and tape drive to the system, see
Installing the Fibre Channel to SCSI Router for the NonStop NS-Series Server on
page 3-1.
Note. For more information on connecting the serial cable to the system, see Using the
Serial Interface on page B-1.