HP 4100GL - Manual (Page 42)

TACACS+ Authentication
Configuring TACACS+ on the Switch
For example, here is a set of access options and the corresponding
commands to configure them:
Console Login (Operator or Read-Only) Access: Primary using TACACS+ server.
Secondary using Local.
HPswitch (config)# aaa authentication console login tacacs local
Console Login (Oper- Primary Secondary
ator or Read-Only
Access)
Console Enable (Manager or Read/Write Access: Primary using TACACS+ server.
Secondary using Local.
HPswitch (config)# aaa authentication console enable tacacs local
Console Login (Oper­
ator or Read-Only Primary Secondary
Access)
Telnet Login (Operator or Read-Only) Access: Primary using TACACS+ server.
Secondary using Local.
HPswitch (config)# aaa authentication Telnet login tacacs local
Console Login (Oper­
ator or Read-Only Primary Secondary
Access)
Telnet Enable (Manager or Read/Write Access: Primary using TACACS+ server.
Secondary using Local.
HPswitch (config)# aaa authentication telnet enable tacacs local
Console Login (Oper­
ator or Read-Only Primary Secondary
Access)
Deny Access and Close the Session After Failure of Two Consecutive Username/Password Pairs:
HPswitch(config)# aaa authentication num-attempts 2
Attempt Limit
2-14