Configuring radius accounting – HP 4100GL User Manual
Page 70
RADIUS Authentication and Accounting
Configuring RADIUS Accounting
Configuring RADIUS Accounting
RADIUS Accounting Commands
Page
[no] radius-server host < ip-address
>
3-19
[ acct-port < port-number >]
[key < key-string >]
[no] aaa accounting < exec | network | system >
< start-stop | stop-only> radius
[no] aaa accounting update
periodic < 1 .. 525600 > (in minutes)
[no] aaa accounting suppress null-username
show accounting
show accounting sessions
show radius accounting
N o t e
This section assumes you have already:
■
Configured RADIUS authentication on the switch for one or more
access methods
■
Configured one or more RADIUS servers to support the switch
If you have not already done so, refer to “General RADIUS Setup Procedure”
on page 3-5 before continuing here.
RADIUS accounting collects data about user activity and system events and
sends it to a RADIUS server when specified events occur on the switch, such
as a logoff or a reboot. The Series 4100GL switches support three types of
accounting services:
■
Network accounting:
Provides records containing the information
listed below on clients directly connected to the switch and operating
under Port-Based Access Control (802.1x):
• Acct-Session-Id
• Acct-Delay-Time
• Nas-Port
• Service-Type
• Acct-Status-Type
• Acct-Input-Packets
• Acct-Output-Octets
• NAS-IP-Address
• Acct-Terminate-Cause
• Acct-Output-Packets
• Acct-Session-Time
• NAS-Identifier
• Acct-Authentic
• Acct-Input-Octets
• Username
• Called-Station-Id
3-16