HP 4100GL - Manual (Page 65)

RADIUS Authentication and Accounting
Configuring the Switch for RADIUS Authentication
For example, suppose you have configured the switch as shown in figure 3-3
and you now need to make the following changes:
1. Change the encryption key for the server at 10.33.18.127 to "source0127".
2. Add a RADIUS server with an IP address of 10.33.18.119 and a server
specific encryption key of "source0119".
Figure 3-3. Sample Configuration for RADIUS Server Before Changing the Key and
Adding Another Server
To make the changes listed prior to figure 3-3, you would do the following:
Changes the key
for the existing
server to
"source0127" tep
Adds the new
RADIUS server
with its required
"source0119" key.
Lists the switch’s
new RADIUS
server
configuration.
Compare this with
(s
Figure 3-4. Sample Configuration for RADIUS Server After Changing the Key and Adding Another Server
To change the order in which the switch accesses RADIUS servers, refer to
“Changing RADIUS-Server Access Order” on page 3-27.
3-11