Maintenance, Maintenance schedule – Husqvarna 15 C User Manual

Page 25

Advertising
background image

English –

23

At least

once

a year

50 100

Page

Maintenance interval

in hours

MAINTENANCE

25

Maintenance

Daily

mainte-

nance

before start

● = Described in these instructions.
❍ = Not described in these instructions.

WARNING!
No service procedures must be conducted on the engine or cutting unit unless:

Maintenance schedule

The following is a list of the maintenance which should be conducted on the machine. For the items which
are not described in these instructions go to an authorised service workshop.

1)

First change after 5 hours. Replace after every 25 hours with heavy loads or high temperatures.

2)

During dusty conditions cleaning

and replacement should be more frequent.

3)

For daily use of the machine lubrication should be conducted twice a week.

4)

Conducted by

authorised service workshop.

5)

Rider 13 AWD only. Replace first after 8 hours.

Cleaning

24

●

Check the engine’s oil level

42

●

Check the engine’s cooling air inlet

35

●

Check the fuel pump’s air filter

32

●

Check the steering wires

27

●

Check the brakes

28

●

Check the battery

32

●

Check the safety system

33

●

Check screws and nuts

–

❍

Check for fuel and oil leakage

–

❍

Clean around the silencer

–

❍

Inspecting the silencer

26

●

Change the engine oil

1)

42

●

1)

●

1)

Clean the air filter’s pre-filter

2)

31

●

Check the cutting unit

36

●

Check the tyre pressures (60 kPa / 8.5 PSI)

35

●

Lubricating the belt adjuster

3)

43

●

Lubricate joints and shafts

3)

44

●

Adjust the brakes Rider 11 and Rider 11 C

28

●

Check the V-belts

–

❍

Check the transmission’s cooling flanges
Rider 13 C, Rider 13 AWD and Rider 15 C

–

❍

Check the transmission’s oil level
Rider 13 C, Rider 13 AWD and Rider 15 C

43

●

Adjust the brakes Rider 13 C and Rider 15 C

28

●

Adjust the brakes Rider 13 AWD

29

●

Check and adjust the throttle wire

30

●

Clean the cooling flanges on the engine and
transmission

2,4)

–

❍

Replace the air filter’s pre-filter and paper filter

2)

31

●

Replace the fuel filter

30

●

Replace the plug

32

●

Check the valve clearance

4)

–

❍

Check the need of an oil change

4,5)

in

the gearbox/hydraulic system

–

❍

❍

• The engine is switched off.

• The ignition key is removed.

• The ignition cable is removed from the plug.

• The parking brake is applied.

• The cutting unit is disengaged.

200

Advertising
This manual is related to the following products: