HP 2170 - Manual (Page 54)

hp psc 2170 series
chapter 8
48
connect your hp psc to your computer
Your HP PSC supports HOT Swapping, meaning you can connect to the HP PSC
while the power is on at your computer and on the HP PSC.
Note: HP recommends that you install the HP PSC software before
attempting to HOT Swap your HP PSC.
connect your usb port
Connecting your computer to your HP PSC with USB is straightforward. Simply
plug one end of the USB cable into the back of your computer and the other in
the back of the HP PSC.
Note: HP recommends a USB cable of 3m or less.
Note: AppleTalk is not supported.
connecting to the USB port on your computer
connect your hp psc to more than one computer
You can connect more than one computer to your HP PSC by using a powered
hub. Both computers must have the HP PSC software installed. Connect each
computer to the hub, then connect the hub to the HP PSC.
remove and reinstall your hp psc software
Do not simply delete the HP PSC program files from your hard drive. Be sure to
remove them properly using the uninstall utility provided in the HP PSC program
group.
what works what does not work
Plugging into the USB port on your
computer Plugging into the USB port located
on the keyboard
Plugging into a powered hub that is
connected to the USB port on your
computer Plugging into a non-powered USB
hub