HP XU800 - Manual (Page 100)

100
5 HP BIOS
Adaptec SCSISelect Configuration Utility
Extended BIOS Translation for DOS
drives > 1 GByte Enabled Includes an extended translation scheme that supports
disk drives of more than 1 GByte.
Verbose/Silent Mode Verbose Displays messages on the screen at POST.
Host Adapter BIOS Enabled Controls the state of the BIOS at POST.
Support for Removable Disks Under
BIOS as Fixed Disks Disabled No removable media drives running under DOS are
treated as hard disk drives. Driver software is required
because the drives are not controlled by the BIOS.
Display <F6> message during
BIOS Initialization Enabled Displays
Press F6 for SCSISelect(TM)
Utility!
BIOS Support for Bootable CD-ROM Enabled Enables booting from a CD-ROM.
BIOS Support for Int 13h Extensions Enabled Host adapter BIOS supports Int 13h extensions.
Domain Validation Disabled Downgrades the performance while maintaining the
integrity of data transmission
Advanced Configuration Options
Options Default
Settings Comments
SCSI Device Configuration Options
SCSI Device Options Default
Settings Comments
SyncTransfer Rate 160 Determines the synchronous data transfer rate that
the host adapter will negotiate with the device.
Enable Disconnection Yes Determines whether the host adapter allows a SCSI
device to disconnect from the SCSI bus (also referred
to as Disconnect/Reconnect).
Initiate Wide Negotiation
(16-bit adapters only) Yes Allows the adapter to initiate wide negotiation with a
16-bit SCSI device.
Send Start unit Command Yes Determines whether the host adapter sends the Start
Unit command to the SCSI bus.
Enable Write Back Cache N/C Allows the BIOS to program the state of the write
back cache in the hard disk drive.
BIOS Multiple Lun Support No Allows the BIOS to support multiple logical units.
Include in BIOS Scan Yes Determines whether the host adapter BIOS supports
devices attached to the SCSI bus without the need for
device driver software.