HP XU800 - Manual (Page 85)

85
3 Interface Cards
Network Cards
INTEL NIC (Network Interconnect) LAN Card
INTEL NIC LAN Card Features
INTEL NIC LAN Card LED Descriptions
Feature Description
Interface
IEEE802.3 100 Base-TX,
IEEE802.3 10 Base-T,
32-bit 10/100 BT full duplex RJ LAN Port.
LED
Two LEDs:
• one for act/lnk (activity and link),
• one for 10 MB operation (on = 100 MB, off = 10MB).
Labels PCI 2.2 Specification, PC 99.
Power Management •
Wfm 2.0 compliant,
• RPO and RWU for APM Windows 95 and Windows 98,
• OnNow 1.0, APM 1.2,
•
PCI power management 1.1,
• VccAux s3.3 V support via PCI bus 2.2,
• VccAux 5 Vsupport via 3-pin WOL.
Manageability DMI 2.0 and DMI 2.0 SNMP mapper.
Diagnostic • Windows and DOS based,
• Mac address DOS report tool,
• User Diag for DOS, Windows NT 4, Windows 95 and Windows 98.
Drivers Major OSes, Minor OSes.
Boot ROM Onboard flash ROM.
Remote Wake Up
(RWU) This feature enables a host computer to remotely (over the network) power
on computers and wake computers up from energy-saving Sleep mode. For
these features to work, use the Setup program to configure the BIOS.
LED On Flashing Off
ACT/LNK Adapter and hub are
receiving power. Cable
connection is good. Receiving or sending
packets Adapter and hub are not
receiving power. Cable
connection could be faulty
or there is a driver
configuration problem.
100 TX Operating at 100 Mbps N/A Operating at 10 Mbps