Hoshizaki ROX-20TA-U - Manual (Page 3)

1
U8AA5540012
I. GENERAL INFORMATION
1. SAFETY INSTRUCTIONS
The following instructions contain important safety precautions and should be strictly observed.
The terms used here are defined as follows:
WARNING: There is a possibility of death or serious injury for the service person and a third
party or the user due to improper service operations or defects in serviced
products.
CAUTION: There is possibility of injury of the service person and a third party or the user or
damage to their property* due to improper service operations or defects in
serviced products.
* The term “damage to their property” here refers to extensive damage to houses, household
effects, livestock and pets.
WARNING
1. When there is no need to energize the unit during disassembly or cleaning, be sure to
unplug the unit or disconnect the main power supply before servicing the unit to prevent
electric shocks.
2. If the unit must be energized for inspection of the electric circuit, use rubber gloves to avoid
contact with any live parts, which may result in electric shocks.
3. Check for proper earth connections, and repair if necessary to prevent electric shocks.
4. Always use service parts intended for the applicable model for replacement of defective
parts. Use proper tools to secure the wiring. Otherwise abnormal operation or trouble
may occur and cause electric leaks or fire.
5. Check for proper part installations, wiring conditions and soldered or solderless terminal
connections to avoid smoke, fire or electric shocks.
6. Be sure to replace damaged or deteriorated power cords and lead wires to prevent electric
shocks, flames or smoke.
7. Lead wires using solderless terminals or the like must be bound with their closed ends up
to avoid entrance of moisture that could lead to electric leaks or fire.
8. After servicing, always use a megohmmeter (DC500V) to check for the insulation resistance
of minimum 1 megohm between the live part (attachment plug) and the dead metal part
(earth terminal). Negligence in checking may cause electric leaks or shocks.
9. Do not service the electrical parts with wet hands to prevent electric leaks or shocks.