HP A7818-IE002 - Manual (Page 39)

System Board
Memory Controller Hub (82850)
Chapter 2 39
The following table shows the features that the MCH host bridge/controller offers.
Feature Feature
• Processor/system bus:
— Supports Pentium IV processor at
100MHz system bus frequency (400MHz
data bus)
— Provides an eight-deep In-Order Queue
that supports as many as eight
outstanding transaction requests on the
system bus
— Desktop optimized AGTL+ bus driver
technology with integrated AGTL +
termination resistors
— Support for 32-bit system bus address
• Accelerated Graphics Port (AGP) interface:
— Single 1.5V AGP Pro connector
— AGP 2.0 compliant, including AGP 4x
data transfers and 2x/4x Fast Write
protocol
— AGP 1.5V connector support with 1.5V
signalling only
— AGP PIPE# or SBA initiated accesses to
DRAM is not snooped
— AGP FRAME initiated accesses to
DRAM are snooped
(snooper identifies that data is coherent
in cache memory)
— Hierarchical PCI configuration
mechanism
— Delayed transaction support for
AGP-to-DRAM reads that cannot be
serviced immediately
• Memory Controller
Direct Rambus:
• Dual Direct Rambus Channels operating in
lock-step (both channels must be populated
with a memory module).
Supporting 300MHz or 400MHz
• RDRAM 128Mbit and 256Mbit devices
• Minimum upgrade increment of 32MB using
128Mbit DRAM technology
• As many as 64 Direct Rambus devices
• Dual-channel maximum memory array size
is:
— 1GB using 128Mbit DRAM technology
— 2GB using 256Mbit DRAM technology
• As many as eight simultaneous open pages:
— 1KB page size support for 128Mbit and
256Mbit RDRAM devices
— 2KB page size support for 256Mbit
RDRAM devices
• Hub Link 8-bit interface to ICH2:
— High-speed interconnect between the
MCH and ICH2 (266MB/sec)