HP OMNIBER 718 HP 37718A - Manual (Page 80)

70
Making Measurements
Making SONET Analysis Measurements
Making SONET Analysis Measurements
Description G.826, M.2101, M.2110 and M.2120 analysis results are provided for all
relevant SONET error sources.
In addition the following results are provided:
Cumulative error count and error ratio
Short Term error count and error ratio
Alarm Seconds
Frequency
Pointer Values
Pointer Graph
HOW TO: 1 Set up the receive SONET interface and payload required. See
"Setting SONET Receive Interface " page 17.
2 If required set up the SONET transmit interface and payload. See
"Setting SONET Transmit Interface " page 4.
3 Press to start the measurement.
4 You can view the analysis results on the
display.
TIP: The measurement will not be affected if you switch between the different
results provided.
RUN/STOP
RESULTS SONET
ANALYSIS