Oil filter change, Servicing your outboard motor – HONDA Outboard Motor BF115A User Manual
Page 70
16 lbf·ft (22 N·m , 2.2 kgf·m)
68
Oil Filter Change
SERVICING YOUR OUTBOARD MOTOR
OIL FILTER
USE A SUITABLE TOOL
OIL DRAIN GUIDE
RUBBER SEAL
Use only a genuine Honda oil
f ilter or a f ilter of equivalent
quality specif ied f or your model.
Using the wrong f ilter, or a non-
Honda f ilter which is not of
equivalent quality, may cause
engine damage.
Clean the oil filter mounting base,
and coat the gasket of the new oil
filter with clean engine oil.
Screw on the new filter by hand
until it contacts the engine, then
use a suitable tool to tighten the
filter an additional 7/8 turn.
OIL FILTER TIGHTENING
TORQUE:
Drain the engine oil, and reinstall
the drain plug, washer and oil
drain cover (see Engine Oil
Change on p.
Use a suitable tool to remove the
oil filter, and throughly drain the
filter into the used oil container.
Tilt the outboard motor, and place
a suitable container below the oil
drain guide to catch the used oil.
4.
5.
1.
2.
3.
05/02/22 12:41:28 31ZW5601_069