Hughes Direcway DW6000 - Manual (Page 131)

Appendix C • Installing the DW6000 using Installer Console
1033295-0001 Revision 2
97
The power supply DW6000 users must use a power supply with the part number
P/N: 1031105-0001. The part number is on a sticker on the power
supply. Verify that you are using the correct power supply. Do not
use anything but the power supply supplied with the DW6000
system (1031105-0001).
Be sure the power supply is labeled ADP 64AB B in the upper
right hand corner of the label, above the bar codes. See Figure 86.
CAUTION
• This unit’s performance may suffer if the wrong power
supply is used.
• This unit must be used with the power supply PN
1031105-0001.
• When power needs to be removed, ALWAYS unplug the
AC power cord from either the wall outlet, surge
protector, or power strip.
• NEVER pull the power cord from the back of the
DW6000. Doing so could damage the pins and also
cause a short in the system.
• Power supply with the part number 1031105-0001 is to
be used only in the United States and Canada.
• This unit must be used with 110-volt AC input.
• Other countries may have different standards and
requirements.
Figure 86: PN: 1031105-0001 and ADP-64AB B above bar code
ADP-64AB B
PN: 1031105-0001