Hughes Direcway DW6000 - Manual (Page 42)

Chapter 2 • Installing the indoor equipment
18
1033295-0001 Revision 2
The commissioning
procedure You must confirm remote location and transponder information
before pointing the antenna. You will point the antenna, achieve
maximum signal quality factor (SQF), and then cross pol the
antenna. Refer to the antenna installation guide for any
instructions on peaking signals.
1. Open a browser on the installer laptop.
2. Type
http://198.162.0.1/fs/advanced/
advanced.html in the address bar and press Enter. The
Advanced screen appears.
3. Click Setup . The Setup screen appears. See Figure 15.
4. Select Registration - Installer . The Antenna Location screen
appears. See Figure 16.
5. Enter the ZIP code of the location where you are installing
the DW6000 and select Next. The Antenna Location screen
appears. See Figure 16. If you wish to enter the site’s latitude
and longitude manually select
Enter location manually and
click next. See Figure 20. Appendix A – Lat/Long Decimals
to Minutes Table, on page 67 shows how to determine latitude
and longitude decimal to minutes conversion.
6. The Verification of Antenna Location screen appears. See
Figure 17. Verify the information is correct and select Next
The
Satellite Parameters screen appears. See Figure 18.
Figure 13: Successful ping
Figure 14: Failed ping