Hughes Direcway DW6000 - Manual (Page 3)

•
1033295-0001 Revision 2
iii
Declaration of Conformity
Standards to which Conformity is declared: FCC Part 15
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
Responsible Party’s name: Hughes Network Systems, Inc.
Address: 11717 Exploration Lane, Germantown, MD 20876
Telephone: 1-866-DIRECWAY (347-3292)
Trade Name: HUGHES, DIRECWAY
Type of Equipment: Two-Way DIRECWAY System
Model Numbers: DW6002 (1032021-0002) DW6000 (1032021-0001)
The Two-Way DIRECWAY System (DW6002 and DW6000) complies with the Canadian
ICES-003, Class B standard.
For DW6002
Standards to which Conformity is declared: FCC Part 68
Part 68 Compliance -- This equipment (Two-Way DIRECWAY System: Model Numbers:
DW6002) complies with Part 68 of the FCC rules and requirements adopted by the ACTA.
On the rear panel of this equipment is a label that contains, among other information, a
product identifier in the format US:5L4DT00B1032021. If requested, this information must
be provided to the Telephone Company.
The Two-Way DIRECWAY system needs to be installed according to the instructions.
Coaxial cables (RX and TX) need to be grounded at the point of entry. A plug and jack
used to connect this equipment to the premises wiring and telephone network must
comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A
compliant 26 Gauge telephone cord and modular plug is provided with this product. It is
required to be terminated with a plug type 605 or a FCC plug type 6 position for Australia.
CAUTION: To reduce the risk of fire, use only No. 26 AWG or larger UL Listed or CSA
Certified Telecommunications Line Cord.
The REN is used to determine the number of devices that may be connected to a
telephone line. Excessive RENs on the telephone line may result in the devices not
ringing in response to an incoming call. In most, but not all areas, the sum of RENs should
not exceed five (5.0). To be certain of the number of devices that may be connected to the
line, as determined by the total RENs, contact the local Telephone Company. For products
approved after July 23, 2001, the REN for this product is part of the product identifier that
has the format US:5L4DT##B1032021. The digits represented by the ## are the REN
without the decimal point (e.g., 00 is a REN of 0.0). For earlier products, the REN is
separately shown on the label.
If the Two-Way DIRECWAY System causes harm to the telephone network, the
Telephone Company will notify you in advance that temporary discontinuance of service
may be required. But if advance notice isn’t practical, the Telephone Company will notify
the customer as soon as possible. Also, you will be advised of your right to file a complaint
with the FCC if you believe it is necessary.
The Telephone Company may make changes in its facilities, equipment, operations, or
procedures that could affect the operation of the equipment. If this happens, the
Telephone Company will provide advance notice in order for you to make the necessary
modifications to maintain uninterrupted service.